• To enter advanced mode, press the central button repeatedly until the probe switches off.

• Press and hold the central button for 5 seconds

• You will then be in the advanced settings menu n°1
• To change the setting value, turn the central knob.
• To go to advanced menu no. 2, press the central button once.

01: Temperature probe calibration: Calibrates the temperature displayed on the probe if it does not correspond to reality.

02: Maximum setpoint temperature: Used to limit the maximum setpoint temperature.

03: Minimum setpoint temperature: Used to limit the minimum setpoint temperature.

05: Frost protection temperature: Used to set the frost protection temperature.

09: Dead zone: prevents simultaneous activation of cooling and heating. 0 = unlocked / 1= locked

10: Default display: Displays the setpoint temperature when the thermostat is on standby = 1 or the room temperature = 0

11: Key lock: Locks thermostat buttons = 1 or unlocks = 0

12: Automatic window detection. Activate window detection mode = 1 or deactivate = 0

13: Window opening detection time : Used to set the detection delay when a window is opened (in min).

14: Window temperature drop sensitivity : Allows you to set the detection sensitivity when a window is open (in °C).

15: Heating cut-out time following window opening : Allows you to set the time (in min) when the heating will be cut off following a window opening.

17: Reset: Resets the thermostat settings = 1 then press the central button for 5 seconds