• First, remove the 6 Phillips screws from the powerbox cover to gain access to the circuit board.

• Make sure your intercom panel is properly connected to the powerbox.
• Please ensure that the connecting cable is in good condition. A shortened or lengthened cable will cause the unit to fail.
• Power the powerbox with batteries or the 15V AC adapter (you must not power the powerbox with batteries and transformer at the same time).

• Press call button on intercom panel.
• The intercom panel should make a ding dong sound. If it doesn’t, please check the tips above.

Reminder: The screen is not touch-sensitive, so please press the touch-sensitive buttons on the underside of the monitor.

• Stand in front of the monitor
• Make sure the monitor is powered by the 5V1A mains adapter.
• With the display off, press twice to enter the monitor menu.
• If the monitor does not switch on, press the ON/OFF button for 2 seconds.

• The red icon indicates where the selection cursor is located.
• Press 3 times to move the cursor to the right.
• Press to enter settings.

• Press 1 x to move the cursor downwards.
• Press to enter the association setting.

• Press 1 x to move the cursor to the right.
• Press to confirm the association.

• A 60-second countdown will start on the monitor.
• During this countdown, press call button once on intercom panel and immediately afterwards, press the PAIR button located on the bottom right-hand side of the electronic board in the Powerbox.

• The countdown should stop immediately on the monitor.
• An icon should inform you of the correct association.
• Please perform a function test by pressing call button on intercom panel to ensure correct operation.