• Rаррrосhеz vоtrе рlаtіnе dе ruе du mоnіtеur.
• Роѕіtіоnnеz vоtrе рlаtіnе dе ruе аfіn d’аvоіr ассèѕ аu dеѕѕоuѕ.
• Utіlіѕеz lе tоurnеvіѕ cruciform аfіn dеvіѕѕеr lа intercom panel.

• Remove the intercom panel from its wall bracket.
• ATTENTION: when separating the intercom panel from its support, do not pull sharply. or the cable may be pulled from solar panel intercom panel .

• Remove the rubber cover on the right-hand edge of your intercom panel.
• Turn ON/OFF switch to ON.
• Your intercom panel should emit a “ding dong” when switching. If not, recharge the battery for 12 hours using the supplied usb-c cable.

• Stand in front of the inner screen.
• Make sure the blue LED on your monitor is lit (if the LED is off, please check the 5V power supply on the AC adapter).
• Black screen, press twice to enter the settings menu.

• The blue logo corresponds to the selected menu.
• Press three times to move the blue cursor to the setting menu .

• Press the button once to enter the settings menu.

• Press once to select the association menu .
• Press the button once to confirm the menu.

• The association menu will split into 2.
• Press once to turn the logo blue.

• Press once to set your monitor to receive mode.
• A 30-second countdown will appear on the display.

During the 30-second monitor countdown :

• Press call button once to wake up intercom panel, which should emit a “ding dong”.
• Immediately press the association button for 2 seconds on the right edge of the monitor.
• The monitor countdown should stop immediately (if not, make sure the monitor and intercom panel are close together).

• The monitor and intercom panel are now linked. Please check that it is working properly.
• Press call button on intercom panel and the monitor should beep after a few moments.