• First, make sure the intercom is working properly. Pressing call button should make your indoor monitor ring.
• You can only have one access code to control the gate or the electric strike plate.

• In case of doubt or programming error, reset the keypad administrator code at recommended.
• Wake up the monitor by clicking once on
• Enter the monitor settings menu by clicking a second time on

• Navigate the menu by pressing four times so that the settings icon lights up orange.
• Then click on to enter the settings menu.

• This menu consists of two parts
• Press five times so that the keypad setting lights up orange.
• Then click on to reset the administrator code. The intercom panel will emit 1 confirmation beep.
• The new administrator code is 11111111

The default access code is 000. In our example, we change it to 678

If you wish to change it on the intercom panel

• Enter 11111111 then * ( intercom panel emits a long beep. The bell and nameplate flash 3 times and then go out)
• Type 51 then * ( intercom panel emits a short beep and the name tag lights up steadily)
• Enter 678 then * (The intercom panel emits two short beeps and the nameplate flashes 3 times).
• Press # 3 times to exit the menu.

The new code to unlock the dry contact for the gate will be 1 then 678.

The new code to feed electric strike plate will be 2 then 678

This step is not mandatory.

The default administrator code is 11111111. In our example, we change it to 12345678

• Enter 11111111 then * ( intercom panel emits a long beep. The bell and name tag flash 3 times and then go out)
• Type 50 then * ( intercom panel emits a short beep and the bell lights up steadily)
• Enter 12345678 then * ( intercom panel emits two short beeps and the bell flashes 3 times)
• Press # 3 times to exit the menu

The new administrator code is 12345678